tangency

英

美

网络  切线连续; 接触; 相切; 切向参考; 切矢连续

复数：tangencies　

英英释义

noun

• (electronics) a junction where things (as two electrical conductors) touch or are in physical contact
  1. they forget to solder the contacts
  Synonym:contact
• the state of being tangent

双语例句

• Given a NURBS curve, perturbation for control points is chosen and the LSM ( Least Square Method) is used to modify the geometric features such as position, tangency or curvature of the selected parametric point on the given curve.
  通过对NURBS曲线的控制顶点扰动，采用最小二乘法修改曲线上给定一点处的位置、切矢和曲率等几何特征，并讨论了多点几何特征同时修改的情况。
• The asset pricing model and this is critical assumes everyone is rational and holds the tangency portfolio.
  资本资产定价模型是非常重要的模型-，假设每人是理性的，并持有切线资产组合。
• Emergency Solution to the Equipment Failure of Subnet Access Node in Tangency SDH Loop
  相切组网SDH子网接入点失效的应急方案
• Aiming at the problem of tangency point reorganization of digital curve, this paper proposes a digital curve tangency point detection technology based on rotate-angle accumulation.
  针对数字曲线的切点识别问题，提出一种基于转角累加的数字曲线切点检测技术。
• Then everyone should be holding the tangency portfolio.
  所有人都应该持有切线投资组合。
• The optimal allocation of the certainty and severity of penalty under the cost restrain is the point of tangency of the curve of equal deterrence and the curve of equal cost of deterrence.
  成本约束下的刑罚确定性与严厉性的最优配置是等威慑水平曲线与等威慑支出曲线的切点。
• Then finally, the final step is to find what is the tangency line that goes through the riskless rate.
  在最后，最终的步骤是找出一条，穿过无风险收益率的切线。
• The essence of arc joining is making the tangency of the arc and line or the arc and arc. The programmed Drawing method of arc joining based on AutoCAD secondary-development is studied in this article. The Visual LISP drawing program of arc joining is merited.
  圆弧连接的本质就是使圆弧与直线或圆弧与圆弧相切，在此研究了基于AutoCAD二次开发的圆弧连接程序化绘制方法，用VISUALLISP语言编程建立了圆弧连接通用绘图程序。
• What is the tangency portfolio in this case?
  这个案例中的切线投资组合又是什么呢？
• Through square and triangular permutation ways of cutting identical dimension on steel plate, the first model of computational combinatorics is set up by tangency permutation method.
  模型Ⅰ主要用“相切排列法”通过“方形排列”及“三角形排列”两种情形建立了在一块固定尺寸钢板上切割一种规格小圆板的组合计算模型；